裝載機由于工作環境等因素，出現故障時在所難免的，以下山東永保機械簡單概述山東裝載機拆裝輪胎注意事項。

1、按順序進行，并仔細檢查裝載機所拆裝的部件，是否損壞和變形，拆裝過程中嚴禁用大錘敲擊鋼圈、壓圈和鎖圈。
Sequentially, and carefully check the Shandong loaders detachable parts for damage and deformation, disassembly process non-steel ring with a sledgehammer percussion, compression ring and lock ring.

2、拆裝裝載機前輪時，用方木掩住后輪后，用鏟斗支起前輪，使前輪離開地面5cm后，用方木將車體墊支牢固鏟運機卸載停機方準拆裝。
While working in Shandong wheel loaders, with square wooden cover your rear wheel, with support from the bucket wheel, the front wheel off the ground after 5cm, with square wooden scraper firmly advances the vehicle shall be allowed to stop the demolition of unloading loading.

3、拆裝裝載機后輪時，用長度不小于4m的工字鋼或液壓頂（規格為不小于120mm）斜放適當角度，鏟運機向后行駛，當后輪離開地面5cm時，停止行駛，并用方木掩住前輪，同時用方木將車體墊支牢固方準拆裝。
While working rear wheel loaders Shandong, with a length of less than 4m or hydraulic jacking beam (size of not less than 120mm) diagonal appropriate angle, scrapers traveling backwards, when 5cm rear wheel off the ground, stop driving and with square wooden cover your front wheel while the vehicle advances square solid wood are allowed entry.