側卸式裝載機，是靠鏟斗將巖石鏟起，用側卸的方式將巖石裝入礦車。由于活動范圍比較大，掘進工作面空間比較狹窄，所以側卸式裝載機在工作和檢修時容易引起擠傷人員，擠壞支架、電纜、設備等事故。為防止事故的發生，山東永保機械的有關工作人員提醒大家在操作側卸式裝載機的時候要注意一下幾個方面：

1、機器工作前必須通知附近人員撤離，避免機器對人員造成擠碰;
Must notify nearby evacuation avoid impingement causing the machine to the staff before the machine work;
2、 操作中應經常檢查電纜是否完好，避免壓壞，避免與油管發生摩擦，引發火災事故，應保證所有操作按鈕完好;
Operation should always check that the cable is intact, avoid crushing avoid friction with the pipe, causing fires, should ensure that all action buttons intact;
3、 裝巖前，應對巖堆灑水滅塵，無論沒水或?yàn)⑺b置損壞，都不能開機裝巖;
Before the rock, the rock pile to deal with dust suppression sprinkler, whether or not water sprinkler damage, can not boot rock;
4、裝載機上的照明裝置一定要完好，使工作人員有一個良好的視線，避免擠傷人員的事故發生。同時良好的照明對提高生產效率也是非常有利的;
Lighting devices on the loader must be intact, so that staff have a good line of sight, to avoid the occurrence of accidents crushing people. Good lighting while improving production efficiency is very favorable;
5、 裝載機工作和檢修時，工作人員，特別是區(隊) 長要注意掘進頭的情況。發現有透水、冒頂、煤巖突出征兆時，應立即組織人員撤離到安全地方，并采取相應的措施;
When the loader work and maintenance staff, especially district (team) should pay attention to the situation long boring head. Found flooding, roof fall, when coal and rock prominent signs should organize personnel immediately evacuated to a safe place and take the appropriate measures;
6、當裝載機舉起鏟斗時嚴禁人員在鏟斗下方操作或進行檢修。必須進行修理時，應有可靠的安全措施;
When the loader to lift the bucket at the bottom of the bucket is prohibited personnel operating or maintenance. When repairs must be carried out, should be a reliable safety measures;
7、 司機離開機器時必須切斷電源。非機組操作人員不得擅自操縱機器，以免誤操作而傷人。此外，檢修結束后，等所有工作人員撤離機器周圍后方可開機試車;
Drivers must cut off the power when you leave the machine. Non-crew operations personnel are not allowed to operate the machine, in order to avoid misuse and wounding. In addition, after the overhaul, such as the withdrawal of all staff around the machine before boot after trial;
8、不得用裝載機進行調車。軌道的鋪設，應保持裝巖機最突出的部位，與巖幫之間的距離不小于500毫米。
Shall be adjusted by the loader vehicle. Laying tracks, rock loader should remain the most prominent position, and the distance between the rocks to help not less than 500 mm.