濟南裝載機應該如何正確駕駛？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：818次
一、檢查車輛
1、檢查行車、駐車制動可靠性。
Check the traffic, the parking brake reliability.
2、檢查空載時鏟斗系統運行情況。
Check the operation of the system when the bucket load.
3、檢查燃油、冷卻水及潤滑油情況。
Check the fuel, cooling water and lubricating oil situation.
二、起步
l、起步前觀察四周，確認無妨礙安全行車的障礙后，先鳴笛，再起步。
Look around before the start, after confirming that no obstacles impede safe driving, first whistle, and then started.
2、制動氣壓表讀數達到規定值方可起步。
Brake pressure gauge reading reaches a predetermined value before starting.
3、起步時不得突然加速，應平穩起步。
May not start suddenly accelerated, should smooth start.
三、行駛
1、行駛前取下前后車體安全聯接桿，并妥善保管。
Remove the front and rear body before driving safety coupling rod, and safekeeping.
2、應盡量避免在斜坡橫向行駛及鏟裝物料?！?br />
Should avoid driving and shoveling materials lateral ramp.
3、改變行駛方向及變換驅動操縱桿必須在車停后進行。
Change direction and change the drive lever must be in the car parked.
4、運載物料時，應保持動臂下鉸點離地面400mm以上。不得將鏟斗提升到最高位置運送物料。
When carrying materials should be kept under the hinge point of the boom more than 400mm from the ground. Bucket may not be elevated to the highest position for delivering materials.
5、在坡道上行駛時，應使拖起動操縱桿處于接通位置，拖起動必須是正向行駛?！?br />
When traveling on ramps should make the drag start lever in the ON position, dragging starter must be traveling forward.
